Why add water to the stone engraving machine during use?
The standard stone engraving machine and tombstone engraving machine are both dual-cooled. On the one hand, because the stone material is hard, the cutter head should be water-cooled when working. On the other hand, the spindle is water-cooled to prevent the spindle temperature from being too high. Play a certain protective role. However, if the customer does not pay attention or does not work according to the training steps, there will be a phenomenon of dry burning without water, causing serious damage to the machine itself.
Dry burning of the spindle of a stone engraving machine is most likely to cause the spindle to overheat, and the temperature is too high to cause burning. Generally, after the spindle is burned, the broken spindle must be returned to the factory for repair. Then repair it and send it back from the factory. The cycle of one round and one round will be about 1 week, which will seriously delay the normal processing period. If the customer is in a hurry to order, it will cause great losses. Therefore, when customers are processing, they must follow the training of factory technicians to ensure the normal use of the machine and extend the application cycle of the machine.
If the spindle of the stone engraving machine is not cooled by water, it will always be in a state of continuous high temperature heating. It is easy to cause the spindle to jitter or dislocation, the engraving will be fast and slow and unstable. On the one hand, the accuracy will be affected. On the other hand, the misalignment of the spindle will cause the engraved sample to be misaligned. The engraved sample is naturally full of loopholes and is very imprecise.