The spring of 2020 is an unforgettable season. The world is struggling to fight COVID-19. The prevention and control of COVID-19 is the current top priority. We are serious, firm and serious in the face of the epidemic!
Regarding the resumption of work after the holidays, ULI-CNC has sorted out some precautions for the woodworking engraving machine for you, hoping to help you:
1. Check whether the power supply and air source of the workshop are in place normally, and the water from the air source processor is re-discharged;
2. Check and clean up the debris and dust on the machine, and do a good job of cleaning;
3. Check whether there are mice and other animals biting the wires in the electric box, and whether the electrical parts are normal;
4. Clean the grease and dust on the guide rails, screw rods, racks and gears;
5. After completing the above four items, the machine should run idly for about ten minutes to preheat and run the machine.
The above are the precautions for starting the machine after the year. The engraving machine is like a car. Maintenance is greater than repair. The so-called seven-point maintenance and three-point repair, so that the service life of the engraving machine can be longer.
How to maintain the engraving machine? Today ULI-CNC has sorted out the following maintenance points for you:
Working environment:
1. Ensure the ambient temperature of the operating room, pay attention to the temperature of the operating room in winter.
2. Check the applicable temperature of the refueling standard, and at least reach the low temperature.
3. When the machine is not in use, if the room temperature is low, the water in the water tank should be poured out to prevent the water tank and water pipes from freezing and cracking. The effect of temperature on the engraving machine is not very big, but because many customers add butter to the screw and forget to clean it in winter, it will not work every time the machine is turned on, and the temperature in some studios is very low. On, the machine can't run.
4. The humidity in the operating room should not be too large, otherwise the electrical accessories of the machine will be easily worn out.
5. Be sure to pay attention to the electromagnetic interference in the operation room. If the interference is too large, it will easily affect the machining accuracy of the engraving machine.
Sanitary cleaning:
After the engraving machine is used, be sure to clean up the dust, sawdust, etc. on the countertop and exposed electrical accessories, including the machine's guide rails and sliders, including the machine's lead screw and spindle motor. Including the industrial control box of the machine, especially if there is too much dust in the industrial control box, it will cause problems in the operation of the circuit board, and it is easy to break points and run around.
Computer maintenance:
Most of the engraving machines use computers to operate, and once the computer fails, the entire engraving machine cannot be used, so it is also very important to maintain the computer. Computer maintenance pay attention to the following aspects.
1. Regularly clean the dust of the chassis, use an air spray gun and a small brush to clean it regularly, and be careful that too much dust may cause the industrial control card to come out. Pay attention to the heat dissipation device of the chassis, especially in summer, be careful that the temperature of the control line is too high and the circuit board and other equipment are burned out.
2. Regularly clean up computer junk, defragment disks, optimize the computer system, and maintain the stability of the computer system.
3. Regularly check and kill computer viruses, but pay attention not to open the anti-virus level when working, and be careful of interference.
The above is about the maintenance and maintenance of the woodworking engraving machine. If you have other opinions and suggestions, you can contact us at any time~