The tool of the CNC engraving machine is the key to engraving. We need to pay special attention to the loading and unloading of the tools. Considering the quality of the future engraving of the CNC engraving machine, today we will talk about the loading and unloading of the Hangzhou CNC engraving machine. Process.
1. Check the storage capacity of the coolant in the motor spindle cooling before use, turn on the motor spindle cooling to ensure the normal circulation of the coolant. Open the positive pressure seal to prevent the disposal of waste liquid, coolant, etc. Prevent entry into the motor spindle bearing.
2. The blade loading material must be strong. The guidelines of "installation, installation straight, and installation level" must be followed to prevent engraving of hanging materials.
3. When installing the clamping tool, you must first clean up the dust and debris in the chuck, install the chuck in the gland and align it, then install the chuck together on the motor spindle, insert the tool into the chuck, Then tighten the gland. When the upper knife and the lower knife are tightened and capped, the push-pull method should be stopped and the rotation method should be used. When putting down the cutter, clean the gland and rotating waste first, loosen the gland and remove the cutter, then unscrew the gland and take it out of the chuck.
4. When installing the clamping tool, the length of the exposed clamping head of the tool should be determined with reference to the engraving depth file and fixture. Under satisfactory conditions, the length of the exposed chuck should be as short as possible. When the total length of the tool is less than 22 mm, continue to use it is prohibited.
5. The length of the knife and the handle extending into the chuck must be greater than 18 mm.