1. The engraving machine cannot be placed in a dark and humid place, nor can it be exposed to strong light. Choose a well-ventilated place.
2. The engraving machine must be maintained regularly, just like the regular maintenance of a car, the screw rod should be cleaned, and lubricating oil should be dripped on the track and rotating parts frequently to ensure the normal operation of the machine and improve the working efficiency of the engraving machine , to reduce unnecessary loss.
3. Every day before work, check whether the control box and wiring are loose, and whether there is any wrong wiring. Long-term operation depends on whether the wire sheath is damaged and causes leakage.
4. Do not often use one side of the engraving machine to work, which will cause the screw and guide rail to not be in contact with the beam for a long time and cannot be properly lubricated.
5. The woodworking engraving machine is very dusty when working, so the gaps and dead corners of the machine should be cleaned at least once a week.
6. Do not place debris, corrosive or magnetic substances that can interfere with the work of the engraving machine.
7. Configure a voltage regulator, because the power consumption of engraving machines is generally relatively large, so ensure that the ground wire is grounded.
8. The computer connected to the machine and the computer working on the network should be used separately, and regular CD-ROM software should be used to prevent viruses from attacking the computer and machine and affecting the normal operation of the engraving machine.
9. The continuous running time of the woodworking engraving machine is less than 10 hours a day. It is necessary to keep the cooling water clean and the water pump to work normally. If the working environment temperature is too low in winter, you can replace the water in the water tank with antifreeze.